To use our cable with Atmel's reversed pin-number header you'll either need to cut off the ribbon connector locating lug and plug it in backwards, or select the LEMTA option below to order with the 10-pin ribbon connector fitted backwards. WARNING for ATMEL-ICE users: The Atmel-ICE has it's header pin numbers reversed (standard pin 1 is Atmel-ICE's pin 10). See also the TC2030-CTX "Legged" version of the cable.įor traditional ARM JTAG solutions using the 20-pin header as found on Segger's J-LINK see our TC2050-ARM2010 adapter used with TC2050-IDC ( -NL) cables. You may also want to purchase a couple of TC2030-CLIP boards which will hold this cable in place for hands-free programming and debugging. Please refer to the TC2030-IDC-NL datasheet below for details of the TC2030-NL footprint. The footprint for the TC2030-CTX-NL Plug-of-Nails™ Connector saves over 66% of the PCB space used by typical FTSH-105 style micro-headers! This special cable has a 6-pin TC2030-NL Tag-Connector and a 10-pin ribbon connector that mates with the FTSH-105 style micro-headers used for Cortex Debug as found in debuggers such as Keil's ULINK-2. The 10-pin IDC can be plugged directly into Atmel-ICE providing 6-pin SPI, TPI, PDI, aWire and debugWIRE connections similar to the (now obsolete) Atmel AVR JTAGICE MkII.ĭatasheet (for details of the TC2030 connector and footprint only)Ħ-Pin "No Legs" TC2030 Plug-of-Nails™ programming cable for use with ARM Cortex processors. The TC2030-ICESPI programming cable is a special cable for use with Atmel-ICE AVR that has a 6-pin TC2030 Legged Tag-Connector at one end and a 10-pin 0.05" (1.27mm) pitch female IDC ribbon connector at the other. Note also that Atmel-ICE outputs the PDI and aWIRE DATA on a different pin to JTAGAVR MKIIĭatasheet (for details of the TC2030-NL connector and footprint only) Our LEMTA cables similarly have a reversed connector). (Atmel ICE comes suppplied with a ribbon cable fitted with two 10-pin IDC connectors and a 6-pin single-in-line SIP connector - The 10-pin connector at the Atmel ICE end is reversed but the other is not, correcting the pin-numbering at the target PCB. For Atmel-ICE you should purchase the LEMTA version of our cables which have the 10-pin ribbon connector fitted backwards which corrects for the Atmel-ICE pin numbering reversal. Note: The 10-pin male connectors on the Atmel-ICE have reversed (non-standard) pin numbering. The 10-pin IDC can be plugged directly into Atmel-ICE providing 6-pin SPI, TPI, PDI, aWire and debugWIRE connections similar to the (now obsolete) Atmel AVR JTAGICE MkII. The TC2030-ICESPI-NL cable is a special cable for use with Atmel-ICE AVR that has a 6-pin TC2030 No-legs Tag-Connector at one end and a 10-pin 0.05" (1.27mm) pitch female IDC ribbon connector at the other.